427-1065-00-12 Revision 130
November 2019
11
This document does not contain any export-controlled information.
Camera Installation
1.5
Mounting the Camera
1. Place the supplied template where you will install the
camera. Mark the position of the two screw holes for the
base of the mounting bracket.
2. At the center of the template, a cable entry hole 40 mm
(1.57”) in diameter will provide for hidden cables.
3. Drill the cable entry hole for cables or use the slot for
surface mounting the cables.
4. Drill holes slightly smaller than the supplied plastic
screw anchor on each marked screw hole.
5. Insert the plastic screw anchors into the drilled holes.
6. Connect the camera cables and thread them through the
7. Match the mounting slots of the camera with the plastic screw anchors at the installation loca
-
tion.
8. Fasten the camera with the supplied M4 screws.
9. Loosen the set screws in order to manipulate the cam
-
era positioning at the ball joint. The camera can be
rotated, twisted, and pointed up or down at the ball joint.
10. Point the camera in the desired direction and fasten the
screws.
M4 mounting
slots
Slot for surface
mounting
cable
Ball-joint
set screws
Base
set screw
