FLIR Elara 427-0300-40-00, Installation And User Manual

Page: 40 / 60

This document does not contain any export-controlled information.
Operation
35
427-0300-00-12 - Revision 110 - May 2021
Where relevant, changing the settings on the Thermal page immediately affects the live thermal video
images and stream. To save changes, click
Save . To discard changes, click Reset and then Discard
Changes .
3.6 Input/Output (I/O) Page
Adjust local and external I/O settings on the I/O page.
·
For local I/O connections:
Input settings Output settings
If an optional washer pump is connected to pins 3 and 4 (Alarm-Out A1 and A2) on the camera's 14-pin
terminal block connector, the washer controls on the
Wiper Page activate it through local output 1. For
information about how to configure local output 1 to activate the washer pump, see Install and Test the
Optional Wash Kit .
For information about the local I/O connector, see Camera Connections .
·
For external I/O connections, set the current state
for the input and output pins, as shown at right.
You can configure the external I/O connections,
including the number of external input and output
pins, on the
I/O Devices Page in System Settings.