Figure 5.2
Basic Voltage Measurement Setup
1. Set the function switch to the Voltage position
.
2. Short press the MODE button to select AC or DC voltage mode.
3. Insert the black test lead into the negative (COM) terminal and the red test
lead into the positive terminal.
4. Place the probe ends of the test leads in parallel to the part under test.
5. Read the Auto Range voltage measurement on the display.
6. To switch to Manual Range mode, short press the RANGE button. Subse-
quent short presses of the RANGE button will step through the available
ranges. Long press the RANGE button to return to Auto Range mode.
7. Long press the MODE button to read the frequency (Hz) of an AC signal.
8. The available Function Icons in Voltage mode are Settings, MIN/MAX/AVG,
and VFD (AC only). See Section 7,
Function Icons
, for complete details.
5.8
LoZ Voltage Measurements
CAUTION
Use caution when the measured voltage is greater than 30V DC or AC rms.
#NAS100017; r. AB/59644/59644; en-US
11
Summary of Contents for CM65
