7.5
Connecting network and power
Connect an Ethernet cable (PoE, 36–56 V DC) to the connector gland on the bottom of
the housing device. Use the strain-relief clamp that is delivered with the camera:
Follow this procedure:
1. Unscrew the strain-relief clamp into one long (male) part and one short (female) part.
2. Pull out the plastic seal from the long clamp part.
3. Pull the network cable through the short clamp part, the plastic seal, and the long
clamp part, in that order.
4. Connect the network cable to the connector gland on the bottom of the housing.
5. Attach the long clamp part to the connector gland, and then put the seal back.
6. Screw the clamp parts together. Make sure that no strain is put on the network cable.
7.6
Connecting Digital I/O (optional)
Note
• Use the terminal block to connect an external cable to the digital I/O. Do not connect
the cable directly to the camera.
• The external cable is not included on delivery.
Follow this procedure:
1. Loosen the four screws on the sides, and then remove the cover and upper half of
the housing body.
2. Remove the cap from the cable gland to be used on the bottom of the housing, and
then pull the external cable through. Use the smallest cable gland to prevent water
from entering the housing.
3. Connect the external cable (not included on delivery) to the terminal block. The cam-
era itself is already connected to the terminal block.
#T810485; r. AA/76994/76994; en-US
10
