FLIR A500-EST, Getting Started, Page: 8 / 44

2 EN-US English
2.1. Connect the Ethernet cable (M12 to RJ45) to the Ethernet/PoE con-
nector on the camera (Figure 1.1
View from the rear , page 1, item 3).
2.2. Connect a standard Ethernet cable to the Ethernet cable (M12 to
RJ45).
2.3. Connect the other end of the Ethernet cable to the OUT port on the
PoE injector.
2.4. Connect a standard Ethernet cable from the IN port on the PoE in-
jector to the computer.
2.5. Connect the PoE injector to a power outlet. The camera starts
automatically.
3. On the computer, use FLIR IP Config to identify the camera on the network,
and change the IP settings if necessary.
4. Open the camera web interface. Do one of the following:
4.1. Double-click on the camera in FLIR IP Config.
4.2. Type the IP address of your camera into the address bar of a web
browser.
This displays the login view.
5. Log in using the username and password available on the camera calibration
certificate. This displays the web interface of the camera.
6. For instructions on how to set up, configure, and operate a FLIR EST Ther-
mal Screening station, refer to the online documentation.
2.9 View from the rear
See Figure 1.1 View from the rear , page 1.
1. Power/error indicator LED (blue/red).
2. Ethernet communication indicator LED (green).
3. Ethernet/PoE connector, X-coded.
4. Power I/O connector, A-coded.
5. Antenna.
6. RS232/485 connector, A-coded.
7. Factory reset button. For factory reset modes, refer to the camera user
manual.
2.10 View from the front
See Figure 1.2 View from the front , page 1.
8. Infrared sensor.
#T810566; r. AA/70271/70271; mul 5