7
© 2020 FLINT & WALLING, INC. • 95 North Oak St. • Kendallville, IN 46755
flintandwalling.com
Installation (Continued)
Proper rotation of
pump impeller is
critical on three phase motors. See Motor
Rotation under Operation section and
Figure 15.
WIRING
1. Install, ground, wire and maintain this
pump in accordance with your local
electrical code and all other codes
and ordinances that apply. Consult
your local building inspector for local
code information.
2. Ground the pump permanently using
a wire of size and type specified
by local or United States National
Electrical Code. Do not ground to a
gas supply line.
3. Connect ground wire first. Connect
to ground first, then to green
grounding terminal provided on the
motor frame, identified as GRD.
Ground connection MUST be made
to this terminal. Do not connect
motor to electrical power supply
until unit is permanently grounded;
otherwise serious or fatal electrical
shock hazard may be caused.
4. Connect the other end of the ground
wire to a properly grounded service
panel or to a control panel ground
bar if it is connected to the power
supply ground.
IMPORTANT:
Check local and/or United
States National Electric Codes for proper
grounding information.
Make certain that
the power supply
conforms to the electrical specifications of
the motor supplied. See Motor Data
Charts.
Ground motor
before connecting
to electrical power
supply.
Failure to ground
motor can cause
severe or fatal
electrical shock
hazard.
Do not ground to
a gas supply line.
Pump used to boost incoming pressure from a wall hydrant (manual operation).
Figure 8
IL0424
Wall Hydrant
Hose Adapter
Pressure Gauge
Pressure
Relief Valve
Hose Adapter
High Pressure Reinforced Hose
Spray
Nozzle
Service Tee
Outlet
Inlet
High Pressure Reinforced Hose
Hazardous voltage.
Can shock, burn
or cause death.
Ground pump
before connecting
to power supply.
NOTE:
Single voltage (230V) motor, and can not
be connected to 115V.
Figure 10 - Wiring Diagram for Single Phase 3
HP Motors
L1
L2
IL1680
230 VOLT
SINGLE PHASE
LINE
YELLOW
BLACK
GRAY
RED
GRAY
WHITE
GRAY
L1
L2
A
B
L1
L2
A
B
IL0180
YELLOW
115 VOLT
SINGLE PHASE
LINE
230 VOLT
SINGLE PHASE
LINE
WHITE
GRAY
RED
TAN
YELLOW
WHITE
GRAY
RED
TAN
NOTE:
Dual voltage motors, change the red and
gray wire to the voltage required.
Figure 9 - Wiring Diagram for Single Phase 1/3 - 2 HP Motors
