FlinSlim Edge Solar Hybrid Inverter with In-Built Stabilizer
FLIN ENERGY
28
Fault code
08/09/53/57
Internal components failed.
Return to repair center.
Fault code 51
Over current or surge.
Restart the unit, if the error
happens again, please return
to repair center.
Fault code 52
Bus voltage is too low.
Fault code 55
Output voltage is unbalanced.
Fault code 56
Battery is not connected well or
fuse is burnt.
If the battery is connected
well, please return to repair
center.
Appendix I: Parallel function
(Only for 5K parallel model)
1. Introduction
This inverter can be used in parallel with two different operation modes.
1.
Parallel operation in single phase with up to 6 units. The supported maximum output power is
24KW/30KVA.
2.
Maximum six units work together to support three-phase equipment. Four units support one phase
maximum. The supported maximum output power is 24KW/30KVA and one phase can be up to
16KW/20KVA.
NOTE:
If this unit is bundled with share current cable and parallel cable, this inverter is default supported
parallel operation. You may skip section 2. If not, please purchase parallel kit and install this unit by following
instruction from professional technical personnel in local dealer.
2. Package Contents
In parallel kit, you will find the following items in the package:
Parallel board Parallel communication cable Current sharing cable
3. Parallel board installation
This installation steps are only applied to 5K model.
Step 1:
Take the dummy board out by unscrewing two screws.
Step 2:
Disconnect the cable and remove the dummy board.
