background image

General Aviation

Flightcom Corporation

1

7

600

 SW 

65th

 

Ave

Lake Oswego

, OR 97

035

 USA

 

800-432-4342

 • [email protected] • flightcom.net

Copyright © Flightcom Corporation 2019.

 All rights reserved.

Flightcom is a registered trademark of Flightcom Corporation.

 

Specifications subject to change without notice.

600-3039-00 Rev 

C

MAINTENANCE

Care and Maintenance

• Inspect ear seals and mic muff frequently for wear. Replace at 6 month intervals.

If you see any defect such as holes or cracks in the ear domes, ear seals, or
headband, headset should be immediately repaired or replaced.

• Do not remove the foam speaker cover.

• To ensure proper function, keep the microphone away from excessive moisture.

Do not store headset in high temperature environments or direct sunlight.

• Wipe headset and ear seals with a mild soap and water mixture only. The foam

mic muff may be removed and cleaned in a mild detergent, or replaced by
ordering from Flightcom.

WARNING

Never immerse any part of the Headset in water.

To Order Flightcom Accessories: 

Call: 1-800-432-4342

V90SP/MPH

V70SP

V50SP/MPH

V30SP

FLIGHTCOM VENTURE

FLIGHTCOM VENTURE

TM

GENERAL AVIATION HEADSETS

Operation Manual

TM

Summary of Contents for VENTURE V90SP

Page 1: ...ks in the ear domes ear seals or headband headset should be immediately repaired or replaced Do not remove the foam speaker cover To ensure proper function keep the microphone away from excessive moisture Do not store headset in high temperature environments or direct sunlight Wipe headset and ear seals with a mild soap and water mixture only The foam mic muff may be removed and cleaned in a mild ...

Page 2: ...T switch must be installed in order to use the radio The master gain control located in the aircraft radio should be optimized by an avionics technician whenever adding a new model microphone to the system Caution Bias voltage supplied to the microphone must come from voltage and resistance ranges specified above Voltages supplied in excess of those stated in the specifications can cause microphon...

Page 3: ...T switch must be installed in order to use the radio The master gain control located in the aircraft radio should be optimized by an avionics technician whenever adding a new model microphone to the system Caution Bias voltage supplied to the microphone must come from voltage and resistance ranges specified above Voltages supplied in excess of those stated in the specifications can cause microphon...

Page 4: ...ks in the ear domes ear seals or headband headset should be immediately repaired or replaced Do not remove the foam speaker cover To ensure proper function keep the microphone away from excessive moisture Do not store headset in high temperature environments or direct sunlight Wipe headset and ear seals with a mild soap and water mixture only The foam mic muff may be removed and cleaned in a mild ...

Reviews: