Document Number:
MAN – FD932DVD-BLU
Rev:
Q
Revision Date:
12/01/2011
Page 16 of 35
RS485 Controls
Full control of the FD932DVD-BLU & FD932DVD-BLU Ver CV can be achieved through a standard
RS485 port on the rear panel. All controls available on the front panel and all controls on the Blu-ray
remote control are supported. Please refer to the DB25 connector diagram in the FD932DVD-BLU &
FD932DVD-BLU Ver CV manual for connection information.
RS485 Port Configuration:
The RS-485 port is standard 9600 baud, no parity, 8 data bits, 1 stop bit,
and no flow control. It is standard two wires half duplex.
Command Format :
<Prefix><Device ID><Address><Command><Termination>
Prefix:
One Character. All RS-485 remote commands must start with the “
!
” character.
Device ID:
Two Characters.
“BR”
identifies all commands directed to the Blu-ray player.
Address:
One character in the range of
0 - 7.
See Address section below.
Termination:
One Character; ASCII CR. Each command must end with Carriage Return
<CR>.
PA Command:
PA on will enable PA interrupt.
Command Notes:
Each command number corresponds to a remote control pushbutton as shown in
the figure shown below. An optional ASCII Line Feed Char permitted after the Carriage Return
character.
Example:
!BR135<CR> will send a command to Blu-ray player number 1 to play.
!BR139<CR> will send a command to Blu-ray player number 1 to stop playback.
!BR039<CR> will send a command to all Blu-ray players to stop playback.
!BR0PAOFF<CR> will disable PA interrupt.
Note:
The images on the next two pages are only for reference when programming RS485 controls.
The first picture on each page is the actual face used for reference. The second image on each page
is for
RS485 COMMAND REFERENCE ONLY.
The second image contains a text layover of the
actual RS485 command. To determine the RS485 command for Play, look at the first image to
determine the play button, and then look at the second image to determine the command for the
corresponding button.
Example:
!BR04<CR> will send a command to all Blu-ray players to stop.
Available Commands For Units With Serial Numbers x745, x755, and x757 upon request
Actual face for button reference
All manuals and user guides at all-guides.com
all-guides.com
