6
Revision E, December 2009
Specifications
Dimensions
9.5” (W) x 7.25” (H) x 1.25” (D)
Video System
NTSC/PAL
Input Sources
4 Audio/Video Channels
Output Sources
4 Audio/Video Each
Video Impedance
75 Ohms
Control Sequence
Source 1,2,3,4
Audio Impedance
8.2 KOhms
Weight
1 lbs 12 oz
Power
28VDC @ 1.0 Amps
Source Selection
Momentary Ground Switch (Not Incl.)
Materials
Aluminum
Mounting
6 points on flange
DO-160
Section 21 Category B
Installation Instructions
All cabin entertainment equipment, such as the DAPS440, should be installed on
a non-essential bus and have a dedicated circuit breaker. It is a requirement that
a switch be installed so that the pilot can de-energize the system should it
become necessary.
There are six mounting slots located on the sides of the housing. Four holes are
located at the four corners of the back and four holes are located two on each
side of the flange. It is sufficient to mount the display by two attach points. It is
recommended that you leave about
¼
inch of space around the unit for air
circulation.
Audio/Video inputs are paired and listed on the same side of the unit as the
Power Input DB-15. From left to right the video/audio inputs are line 1,2,3,4.
Use the inputs sequentially as you would like them selected by the operator.
On the opposite side of the unit is the output side. Here you will find four paired
output jacks. The momentary ground is pined to the DB-15 to accomplish the
switch of the Audio/Video source.
Power
This is a
28VDC
device that requires 1.0 Amps of power to operate.
All manuals and user guides at all-guides.com
