●
DIATONE 600TVL Miniature Camera
●
Flexible Mini Camera Adjustable Mount
●
●
5V Mini Buzzer for FPV Micro Racing Drones
●
Step 1: Install the motors and center stack screws
Locate the bottom plate and mount each motor using the included motor mount screws. It is
best to use all four screws to avoid having a motor pull out in a crash but, for now, it’s fine to just
install two screws. We’re just using them to hold the motors in place during the installation at
this point. Before flying, you should use Loc-Tite (blue) on all four screws.
Leave the motor leads full length for now; we’ll trim them when we solder them to the ESC.
Next, install the nylon screws by pushing them through the 20x20 holes from the bottom of the
frame. These will secure your center component stack. Place a nylon spacer on each screw.
Step 2: Prepare and install the 4-in-1 ESC.
The Cicada 4-in-1 comes with battery leads pre-soldered but we need to install an XT30 battery
connector to these leads. Slide the appropriate heat shrink over the bare wires but do not apply
heat yet. Solder the XT30 to the appropriate leads.
Note that it’s always a good idea to plug a spare XT30
connector (not a battery, just the plug!) into the one being
soldered. This will reduce the chance of warping or melting
2