Page 6
© 2015 FlexRadio Systems, v1.0.2
Repeat the previous procedure for removing the Phillips Front Side Cover screws on the left side of the
FLEX-6300, retaining the screws for re-installation. Keep all removed screws from the previous de-
installation steps separate for re-installation marked as “long” screws. When complete, the FLEX-6300
should look like the image shown below.
Removing the Middle/Rear Side Cover and Rear Top Cover Screws
Remove all three (3) 4-40 X ¼”
Middle and Rear Side Cover
TORX screws
located on the right side of the
FLEX-6300 using the long portion of the “L” TORX wrench. Repeat this procedure for removing the TORX
Middle and Rear Side Cover screw on the left side of the FLEX-6300, retaining all six (6) screws for re-
installation. The image below shows the removal of the right Middle and Rear Side Cover TORX screws.
