FLEX-6000 QUICK START GUIDE, VER. 2.0, 4/14
|
19
Software Defined Radios
FlexRadio Systems
®
3.) (DIRECT FREQUENCY INPUT) Hover your mouse over
the Frequency numbers in the Slice Panel. Click once with
the left mouse button to
highlight
the frequency. Type in the
desired frequency and press
ENTER
. Note that you can enter
frequency in kHz or MHz directly. If the entered frequency is
beyond the displayed panadapter screen an OFF-SCREEN
indicator will be displayed on the panadapter display. Simply
double-click on the off screen indicator to re-center the
panadapter to your desired frequency.
To set the operating MODE:
1.) On the slice receive control panel, right click current MODE
(USB, LSB, CW, AM, SAM, DIGU, DIGL). To display the mode
and the filter selection menu.
2.) Right click on the mode drop down box to select your
operating mode. See the example shown below. Note that
you can select and display three (3) additional "favorite"
MODEs by right-clicking the displayed MODE and choosing
your favorite from the drop down menu.
To Transmit:
1.) Adjust the
RF Power
slider control for the desired RF
output. The range is 0 to 100W nominal.
2.) Adjust the
MIC
slider control for the desired microphone
level. Start with the slider in the center and adjust as needed.
3.) For additional talk power, click the
COMP
button and adjust
the compression slider for the desired level.
4.) If you want to hear your transmitted audio, click on the
MON
(monitor) button and adjust to level with the slider to the
right of the button to a comfortable listening level.
