Flexlock M1018, Manual

Page: 6 / 44

6 English
3.1 General
3.1.1 Locks in Mode 1 and 2
A lock in Mode 1 or 2 has to have user cards programmed to the lock: Open the lock by placing the correct
user card straight onto the lock. To lock in Mode 1, place the card on the lock. In Mode 2 the lock automati-
cally locks after 4 seconds.
3.1.2 Locks in Mode 3, 4 and 5
When a lock is in Mode 3, 4 or 5, any compatible RFID-card (or tag) may be used (Examples of uses are
lockers at health clubs and leisure centers etc): The lock is locked by placing a compatible RFID-card
(or tag) onto the lock. To open again, the exact same RFID-card (or tag) has to be placed onto the lock
again. Once the lock has been opened again it is then ready for a new user.
4 Startup
4.1 Preprogrammed lock
To activate the lock, remove the plastic strip. The lock is
now ready for installation. Note that the service card and the
programming card is also added in advance (In Mode 1 and 2,
can a User card or Ready to use be added, see 7.3 or 7.4.)
4.2 Unprogrammed lock
1. Insert a Flexlock branded battery available through
Swedstyle or your Flexlock dealer. Make sure that the
battery poles are the right way around.
2. Fasten the battery lid.
If you have programming cards and service cards with
the following numbers: 371750-000, 371760-000,
proceed to 4.2.7.
3. Turn the lock over and insert the activation pin in the
socket on the back, hold down for about 3 seconds.
The programming signal will sound for about
7 seconds.
4. Place the programming card onto the lock before the
7 seconds are up. A confirmation signal will sound
and the programming card is registered to the lock.
The lock is now in Mode 1 (factory mode).
7 SEC
4.1
4.2-1
A4 1:1
Skala:
4.2-3
Programming
4.2-4
!