Flexlock M1018, Manual

Page: 10 / 44

10 English
7.7 Reprogram the lock with a pin (add a new unique programming card)
(See 11.2 Advanced troubleshooting.) After resetting the lock
with a pin, it will go back to mode 1 .The old programming card
is erased. Any user or service cards will also be erased.
1. Turn the lock over and insert the activation pin in the
socket on the back, hold down for about 3 seconds.
The programming signal will sound for about 7 seconds.
2. Place the new programming card onto the lock before the
7 seconds are up. A confirmation signal will sound
and the new programming card is now registered to the lock.
3. Program the Service Card. See point 4.2.5-4.2.6.
NOTE! The same unique ID cannot be reprogrammed.
8 Battery changing
When the battery is low, a warning signal will sound, there will also be a warning signal when the
lock is opened or closed. This battery warning signal will sound each 6 hours until the battery is changed.
If the battery isn’t changed, the lock will automatically open and stay open.
NOTE! If your Flexlock Visible should work properly, the battery must be a Flexlock branded battery
available through Swedstyle or your Flexlock dealer. See www.flexlock.se for more instructions on how
to change the battery.
1. Detach the battery cover.
2. Change the battery – make sure the battery poles are
the right way around.
NOTE! Do not close the storage until the function of the battery is verified.
If the battery is missing or broken, you might not be able to open the lock again.
Test the lock with the front open!
We recommend a scheduled battery change, for every third year or maximum after
30 000 openings. Do not wait for the battery warning as a routine procedure.
A4 1:1 Skala:
Programming
7 SEC
!
!