FLEXLIFT FCE 1000/75, Operating Instructions Manual

Page: 135 / 361

GB
Operating Instructions Flat-bed lift table FLEXILIFT-FLUNDER
4
4. S
AFETY
4.1. Safety regulations for scissor-type lift tables
General

Operation only by trained and designated adults.

Eliminate dangers for persons or property before working on the lift table / load.

Observe safety clearances (50 cm) to surrounding objects.

Only install lift table on even, level floor with sufficient load capacity.

Compensate level differences up to max. 10 mm (resurfacing, fixed-point bearing / base plates)

Only use lift table as loading device with floor frame or floor anchoring.

Only load lift table with stated type of load and load distribution.

Only move lift table when not loaded

Secure load on the platform.

Shutdown lift table in the case of faults / safety defects.

and secure against unauthorised use.

Check the safety devices regularly.

Keep the operating instructions near the lift table

Apply safety instructions (enclosed, yellow sticker) in the vicinity of the lift table.
The following are prohibited

Conveyance of persons

Riding on the platform (only for setting up an operator station)

Working on the load during the lifting process

Climbing on the load or platform

Staying underneath the platform / load

Reaching into the lift table / scissor mechanism

Exceeding the maximum load-bearing capacity

Using unsuitable pallet types

Load overhang on one side

Misuse as a load press

Conversions / modifications of the lift table

Installation / operation outdoors (only in the case of corresponding equipment)

Operating the lift table with unlocked rotary platform

Operating the lift table without safety devices / foot protection contact strip
Dangers

Never disable dead man circuit. DANGER OF FATAL INJURY

Never disable foot protection contact strip.

Release operating button immediately in the case of danger

Press EMERGENCY STOP button

Leave the danger area immediately in the case of a falling or tipping load

Do not expose live parts to moisture.

Hydraulic oil can cause skin rashes / damage to health

Replace damaged parts immediately.
Repair and maintenance work
 
Only by authorised specialist personnel
 
Only in unloaded condition and when disconnected from the power and depressurised.
 
Only when safety supports are used
 
Prevent start-up during maintenance / repairs.
 
Wear protective gloves and face protection.

Have the machine checked at least once per year by experts

Service hydraulics components regularly