26
16 Final checks / Starting
16.1 Final checks
Check the following points:
Description
Chapter
Perfor-
med
The duct insulation is performed in
accordance with the manual and the
technical documents
4
The ducts are connected to the
correct ducts
4
Adjustment has been carried out
in accordance with the manual and
projection documents
8
The unit operates normally at all
stages
-
The rotor rotates freely
-
The rotor rotates with heat required
-
Heating switches in
-
The unit has filters both for outdoor
air and extract air
-
16.2 Starting
• Check that the control panel is connected.
• Connect the mains plug to the unit.
• The unit will now start.
• The unit will automatically carry out a start up procedure
of approx. 1 min.
• After the start up procedure the unit will follow the set-
tings that are set up in the control panel.
• Changes in settings are made from the control panel.
• Adjustments have been made in accordance with the
manual and project planning documents (documentation
of ventilation data).
17 CE Declaration of Conformity
This declaration confirms that the products meet the
requirements in the following Council Directives and
standards:
2014/30/EC Electromagnetic
compatibility
(EMC)
2014/35/EC Low-voltage Directive (LVD)
1253/2014
Ecodesign regulation
1254/2014
Energy labelling regulation
Our products have been tested in accordance with parts of:
2006/42/EC Machinery Directive (Safety)
Producer:
FLEXIT AS, Televeien 15, 1870 Ørje
Type:
UNI 4 R
Ventilation unit
Compliance with valid versions of the following standards on
the date on which the declaration of conformity was signed:
Safety standard:
EN 60335-1
EN 60335-2-80
EMF standard:
EN 62233
EMC standard:
EN 55014-1
EN 55014-2
EN 61000-3-2
EN 61000-3-3
The product is CE-marked: 2010
FLEXIT AS
29.11.2016
Frank Petersen
Adm. dir.
The right to give notice of lack of conformity applies to this product in
accordance with the existing terms of sale,
provided that the product is
correctly used and maintained
.
Filters are consumables.
The symbol on the product shows that this product must not be
treated as household waste. It must be taken to a reception station
for recycling of electrical and electronic equipment.
By ensuring correct disposal of the equipment, you will contribute
to preventing negative consequences for the environment and
health that incorrect handling may entail. For further information on
the recycling of this product, please contact your local authority, your refuse
collection company or the company from which you purchased it.
Notice of lack of conformity as a result of incorrect or defective installation must
be submitted to the installation company responsible. The right to give notice of
lack of conformity may lapse if the system is used incorrectly or maintenance is
grossly neglected.
UNI 4 Installation Instructions
