B
Step 3
03
Step 4
04
Step 5
The crank handle can be installed for either left-hand or right-hand orientation simply by reversing
its position as in the following figure.
9
D
C
Using the hex key (A), connect both the left and right side brackets (6, 7) to the bottom legs
using 4 bolts (G).
Please note:
Do not misplace the two brackets (6, 7).
Slightly loosen the adjustable nuts to adjust the length of the drive shaft (5). Insert the assembled
drive shaft into the slots that located at the top of each leg.
Remove the Bearing block
from the crank shaft (8),
change its postion as in
figure, install it for left-hand
using.
Option 1: installing for right-hand orientation
Option2: installing for left-hand orientation
1. Insert the crank shaft (8) into the right leg which has a shaft hole.
2. Use 2pcs bolts (D) and lock firmly with hex key (C).
3. Then insert crank handle (9) into crank shaft (8).
4. The crank handle(9) can be adjusted depending on your preference.
Insert the assembled drive shaft into the slots
that located at the top of each leg
.
1
2
G
A
6
7
7
8
A
8
A
Left Leg
Right Leg
Loosen the adjustable nuts
Insert into the slots
Fully tighten the nuts
Loosen the adjustable nuts
Stretch the drive shaft
Fully tighten the nuts
