6 Strike 2 Setup (Continued)
Secure the kite on the ground
Place the kite on the beach wih the leading
edge facing into the wind.
To secure the kite place sand onto the sail
behind the leading edge tube.
1. Unwind your flying lines while walking
away from the kite.
2. The kite has toggles on the wing tips.
The front toggles carry the main power of
the kite and the rear are used for turning.
3. The front lines are grey, and have a toggle
extender pre attached to the flying lines.
4. Attach the front lines to the front
tow point.
5. Connect the rear lines to the rear
toggle * . The left and right are colour
coded (red for left and blue for right).
6. The kite is now ready for launch. Check
again that the lines are connected to the
correct locations, and the lines are not crossed.
Attaching your flying lines to the Kite
Toggle extender
Front flying line
* The Strike 2 has two toggles, choose the toggle that suits your riding requirements. The rear point will give the lightest bar pressure and
faster turn. The forward tow point will increase the bar pressure for turning and slightly reduced turn rate.