126
PF7/PF7+ Peristaltic Filler with QC14 Pumphead User Manual
Manual configuration:
Network settings may be specific to your organisation.
Contact your systems administrator to ask if you can use the
example settings or to obtain correct configuration details for
IP Address, Subnet Mask and Default Gateway.
The IP address must be unique for each device.
i
The following example settings can be used:
l
IP Address: 192.168.1.13
l
Subnet Mask: 255.255.255.0
l
Default Gateway: 192.168.1.1
26.2 Connecting pump to a PC via Ethernet network—Connection
option 2
i
Direct connection is recommended for first time setup or
when you intend to dedicate a single PC as an isolated
access terminal for the pump.
Connection via Ethernet network can be reinstated after
the first time setup has completed.
Table 29 - Required equipment - Connecting pump to a PC via Ethernet network
PC with an available RJ45 Ethernet socket
Ethernet cable
Network/Router
Anybus Certificate Generator software (Optional for full SSL certificate
compliance) see "Generate a security certificate (Optional)" on page 131
1. Connect the PF7+ to your router or network using the Ethernet port on the rear
of the pump and a standard Ethernet cable.
2. Connect your PC to the same network using either a wired Ethernet connection
or a wireless connection.
3. On the pump display, select Settings > Network. Make a note of the IP address
shown (for example 192.168.1.12).
4. Type this IP Address into the address bar of your internet browser.
5. Proceed to "Initial pump set-up" on the next page
If pump network settings are not configured automatically, check
DHCP is turned on, see "Network" on page 116
If PC settings are not configured automatically, contact your
systems administrator.
