Belt speed reader
Conveyor Site Preparation:
o
Identify where the device will be installed
The device requires 3-1/2” (90mm) of clearance on the pole
Placement outside OR inside the tensioner on the pole is acceptable, but it is
advised to add a pole extender to the pole before placing the device inside a
tensioner
If using a pole extender, then use care that it does not cause an undue tripping
or safety hazard on a catwalk
Placement inside a chute wall is NOT acceptable due to increased risk of
damage to the device and inaccessibility for maintenance
Place the device where it can be serviced
On precleaners, make sure you attach the device so it has enough room to turn
as the blade wears and the pole rotates
On secondary cleaners, make sure you attach the device so it has enough
vertical space to travel as the tips wear
o
Download the BRAND NAME mobile application
1.
Prepare the pole (optional)
. If using a pole extender, then push/hammer the extender into the pole
and turn the draw bolt to 80 in-lbs (9.0 Nm). If using a pole adapter, then slide the adapter over the
pole.
2.
Affix the device.
a.
Depending on the location of the device on the pole, slide the device onto the pole or
remove the top cap completely and reattach around the pole so the keypad faces forward.
Do not affix the device so the keypad faces the conveyor as this will inhibit your ability to
use the Bluetooth® wireless communication button, information button and LEDs for
routine maintenance.
