The TD 10 comes in two separate carrying bags. One bag stores the tubes and the other bag stores
Step 1
– Preparing the parts.
Laying the bottom out and arranging
Step 2
– Installing the bottom in the boat
Install the bottom parts following their numbers. Start at the bow
stern until you get to part # 5.
Part # 4 should be the last one to be put in place.
the final fitting by applying some down pressure in
adjust the side fabric from the tube to the sides of the floor.
Install the 4 pieces of side aluminum profiles by fitting them to the sides of the floor. Check the final
adjustment of the floor.
Step 3
– Inflating the boat
Inflate the tubes. First pump a little air on each tube to help the bottom to
complete the inflation of the tubes. Only after the
inflate the keel of the boat. Inflate the keel until the bottom it straight and has a V shape.
Owner’s Manual – Small boats up to 10ft
The TD 10 comes in two separate carrying bags. One bag stores the tubes and the other bag stores
disassembled bottom.
arranging the rubber parts.
the bottom in the boat
Install the bottom parts following their numbers. Start at the bow with part # 1 and move your way to the
Part # 4 should be the last one to be put in place. First fit part # 4 into part # 5 and slightly raise part #3 to do
the final fitting by applying some down pressure in order to accommodate the whole floor
adjust the side fabric from the tube to the sides of the floor.
4 pieces of side aluminum profiles by fitting them to the sides of the floor. Check the final
pump a little air on each tube to help the bottom to accommodate
e inflation of the tubes. Only after the tubers are inflated to their correct pressure it is t
inflate the keel of the boat. Inflate the keel until the bottom it straight and has a V shape.
Small boats up to 10ft
7
The TD 10 comes in two separate carrying bags. One bag stores the tubes and the other bag stores the
and move your way to the
fit part # 4 into part # 5 and slightly raise part #3 to do
the whole floor in place. Then
4 pieces of side aluminum profiles by fitting them to the sides of the floor. Check the final
accommodate correctly. Then
inflated to their correct pressure it is time to
inflate the keel of the boat. Inflate the keel until the bottom it straight and has a V shape.