when you are back at the dock, run them at maximum speed for about one minute and before turning them
off at once let them run at idle for five minutes
If your Flexboat has a gasoline stern drive
engine compartment, as well as a blower. And always open the engine compartment hood before starting
the engine to prevent fire.
28. Small repairs on the tubes
The inflatable boat manufactured in Hypalon and Neoprene allows the user to r
way. FLEXBOAT inflatables are equipped with a
pieces of fabric in the same color as the boat and sandpaper.
In case of a hole proceed as follows:
1- Clean the surface to be repaired. If there is any greasy substance,
wash the area with soap and water and then dry and clean with a
little acetone
2- Once the surface has been cleaned, choose a piece of fabric that
will cover the damaged area well.
3- Using the piece of fabric as a template, then use a pencil to mark
the area to be repaired
4- Mask the area around the marking done with the pencil, limiting
the area so there is not excess sanding.
5- Then sand th
that this operation produces. The same process should be done on
the piece of fabric that will be vulcanized. After the sanding operation,
both parts will be ready for vulcanization
Owner’s Manual – Small boats up to 10ft
run them at maximum speed for about one minute and before turning them
off at once let them run at idle for five minutes.
stern drive engine you should make sure you have a vapor d
engine compartment, as well as a blower. And always open the engine compartment hood before starting
The inflatable boat manufactured in Hypalon and Neoprene allows the user to repair small holes in a simple
FLEXBOAT inflatables are equipped with a
repair kit
, containing special adhesive for cold vulcanization,
pieces of fabric in the same color as the boat and sandpaper.
n the surface to be repaired. If there is any greasy substance,
wash the area with soap and water and then dry and clean with a
little acetone-based solvent (eg thinner).
Once the surface has been cleaned, choose a piece of fabric that
the damaged area well.
Using the piece of fabric as a template, then use a pencil to mark
the area to be repaired
Mask the area around the marking done with the pencil, limiting
the area so there is not excess sanding.
Then sand the entire area to be repaired, removing all the dust
that this operation produces. The same process should be done on
the piece of fabric that will be vulcanized. After the sanding operation,
both parts will be ready for vulcanization
Small boats up to 10ft
27
run them at maximum speed for about one minute and before turning them
engine you should make sure you have a vapor detector in the
engine compartment, as well as a blower. And always open the engine compartment hood before starting
epair small holes in a simple
, containing special adhesive for cold vulcanization,
n the surface to be repaired. If there is any greasy substance,
wash the area with soap and water and then dry and clean with a
Once the surface has been cleaned, choose a piece of fabric that
Using the piece of fabric as a template, then use a pencil to mark
Mask the area around the marking done with the pencil, limiting
e entire area to be repaired, removing all the dust
that this operation produces. The same process should be done on
the piece of fabric that will be vulcanized. After the sanding operation,