Flexball Italiana S.r.l.
8
4.2.2. Command station series 4500
In order to adjust the friction of the lever, it is necessary to remove the screw A
placed below the plastic base of the command station. With the help of an
hexagon screw driver size 3 mm you can loosen or tighten the screw and the
friction will become correspondingly softer or harder.
Once the friction has been adjusted, close again the hole with screw A.
Important:
In case of a command station for single engine, the friction is present
only on the left lever.
4.3.
Command station set-up
Under the base of the command station there is a plastic cap. Unscrewing it, you can access to the dip-
switches.
Operation:
•
unscrew the plastic cap;
•
set the dip-switch position according to the following table;
•
screw again the cap.
Under the base of the command station it is present the
following label.
This labels indicates the code of the command station, the
serial number and the different dip-switches configuration
according to the type of the command station.
Dip-switch 1
It defines how you want to setup your electronic control lever
•
OFF:
standard start-up mode at power up (see
section 5.xx)
•
ON:
Fast Start-up Mode at power up (see section
5.xx)
Dip-switch 2
Available for further developments
Dip-switches 3 and 4
Identify the delay time between forward reverse commands (inversion of direction)
Dip- switch 3
Dip- switch 4
No delay during inversion of direction
OFF
OFF
Delay of 1 second during inversion of direction
OFF
ON
Delay of 2 seconds during inversion of direction
ON
OFF
Delay of 4 seconds during inversion of direction
ON
ON
