-16-
WARNING
To prevent accidental
starting that could cause
serious personal injury, always remove the
battery pack from the tool when assembling
parts, making adjustments, or cleaning the
tool.
This cordless angle grinder must be used
only with the battery packs and chargers
listed below:
Battery Pack
Charger
2.5Ah
5Ah
8Ah
12Ah
FLEX FX0111 FLEX FX0121 FLEX FX0221 FLEX FX0231
FLEX FX0411 FLEX FX0421
NOTICE: Please refer to the battery pack and charger manuals for detailed operating
information.
USING WITH GRINDING WHEEL (FIG. 12)
WARNING
Always wear safety
goggles or safety glasses
with side shields during power tool
operation. If the operation is dusty, also
wear a dust mask.
WARNING
A grinding guard must be
installed when using a
grindig wheel to provide maximum
protection for the operator.
Check the grinding wheels before application.
Discard wheels that have been dropped,
bumped, subjected to extreme changes in
temperature, or have come into contact with
solvents or liquids.
a. Before beginning a period of work, test the
tool by letting it spin for one minute before
applying it to the workpiece.
b. Make sure that the workpiece is firmly
clamped in place.
c. Hold the tool securely with both hands.
d. Start the tool.
NOTICE: If the battery is inserted when the tool
switch is in the “ON” position, the tool will not run.
Turn the tool off, then back on to begin work.
e. Allow the accessory to reach full speed before
beginning work.
f. For a uniform finish, hold the tool at an angle
of approximately 10° to 15° and apply (Fig.12)
constant pressure. Too great an angle causes
concentrated pressure on small areas, which
may gouge or burn the work surface.
g. Control the pressure and surface contact
between accessory and workpiece.
WARNING
Do not apply too much
pressure. Too much
pressure will cause the tool to overload and
may cause personal injury.
h. When finished, turn off the tool and make sure
that it comes to a complete stop before laying
it down.
10°~ 15°
Fig. 12
