Flex DD 2G 10.8-EC, Operating Instructions Manual

Page: 24 / 328

DD 2G 10.8-EC / PD 2G 10.8-EC
24
1. Assemble the tool head (drill chuck,
angle attachment, bit holder
attachment).
2. Insert the battery.
3. Insert the tool (drill bits, srewdriver bits,
bit holders).
4. Set operating mode according to the
work item (PD ... only).
5. Set torque preselection to the required
setting.
6. Set speed to the required setting.
7. Set the required direction of rotation.
8. Hold the power tool with one hand on
the handle and assume the working
position.
If the power tool is running, never actuate
the direction preselector switch or torque
setting turning dial.
9. Switch on the power tool.
At the end of work:
10. Release the trigger switch.
11. Move the direction preselector
switch (2) to the middle position.
Charger
The CA 10.8 charger is designed to charge
FLEX batteries of the following types
– AP 10.8/2.5,
– AP 10.8/4.0 and
– AP 10.8/6.0.
1 Insertion slot for battery
2 Contacts
3 LED fault message (red)
4 LED charge status (green)
5 Ventilation slots
6 Power cord with mains plug
Displays of LED
Charging process
CAUTION!
Insert only original batteries in the supplied
charger.

Insert the charger mains plug.
The LED fault message and the LED
charge status light up for a short time.
red green
off flashes Battery is charging.
off on
Charging process finished.
Maintenance charging.
See “Charging process”.
flashes off
Battery is too hot or too
cold.
on off Battery or charger is faulty.
See “Fault messages”.