CS 40 WET
13
Hold the base plate flat against the edge of the work piece and lift the
body of tool until the blade is at the correct depth.
Tighten the depth locking lever.
Changing the blade
WARNING!
Do not attempt to cut small pieces. Avoid awkward hand positions where a
sudden slip could cause your hand or finger to come in contact with the
diamond blade. When cutting any material, make sure that.
• When the blade is worn out, it should be changed according the procedure
in
Installing the blade
.
Parallel cut
WARNING!
Make sure that the edge you are using is parallel to the intended cut.
Turn off the tool and remove the plug from the electrical outlet.
Adjust the parallel guide to the desired width from the blade, then tighten
the retaining screw.
0-45°bevel cut
