TRINOXFLEX
23
To give the surface a decorative finish:
Carefully place the electric power tool on
the area to be machined and move the
power tool forwards and backwards in
a linear motion.
Belt sander attachment
BRE 14
-
3 125
WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
Attaching or changing the sanding belt
CAUTION!
Observe the specified running direction of
the belt! Running direction must correspond
with the arrow on the gear head.
Pull out the mains plug.
Press the swing arm towards the rubber
drive roller and hold down
Place the sanding belt over the rollers.
Release the swing arm.
Check that the belt is situated fully on the
rollers.
Adjusting the handle
When working in areas which are difficult to
access, e.g. handrails attached to walls, the
handle can be attached to the other side of
the swing arm.
Work instructions for the pipe belt
sander attachment
NOTE
When the appliance is switched off, the
grinding tool continues running briefly.
A belt sander has the following advantages
over a grinding disc:
– cool sanding,
– clean finish without grooves,
– high stock removal rate,
– high productivity on account of large angle
of contact (depending on diameter).
Sanding:
NOTE
After placing the machine on the workpiece
and before switching it on, check that the
belt is situated fully on the rollers.
– Pipes are machined between the rollers
11 and 12.
– The angle of contact and the stock removal
rate can be varied by the contact pressure.
