11
ELEVATOR INSTALLATION (continued)
5. Slide the elevator pivot tube through both sets of bearings just until the end of the tube is flush with the outside face of the
bearing . While holding the elevator in one hand, carefully slide the wheel collar down into the slot until you feel it catch
the end of the elevator pivot shaft. (you might have to wiggle the elevator slightly while gently pushing inboard on it
to “catch” the bearing)
6. Using a 1.5mm Hex wrench, tighten the set screws in the wheel collars to secure the elevators to the fuselage.
6. Reinstall the cover plate on bottom of fuselage using the two M3x10 self-tapping screws and a #1 Phillips screwdriver.
NOTICE
To ensure proper elevator operation, be sure the elevator moves freely after installation.
Failing to skip this step could result in servo failure or crash and loss of the airplane.