Once your receiver is bound, powered, and connected to the Aura, the Aura will begin the Auto-Detect process to learn
what type of receiver you are using and set itself up for that specific system.
Auto-Detect is indicated by a series of sweeping LEDs of various colors on the FT Aura 5 Lite. After Auto-Detect is
completed, verify that Aura is on and receiving data from your receiver by looking at the LEDs on the Aura.
Ready-To-Fly:
Solid Orange LED
(Aura On and Calibrated)
Solid Green LED
(Aura Receiving Valid receiver data)
CONNECTING YOUR RECEIVER TO AURA (Auto-Detect)
FT Aura 5 Lite Auto-Detect
Possible Errors:
Flashing Orange LED
(Aura Moved During Power Up)
No Green LED
(Aura NOT Receiving Receiver Data)
ESC THROTTLE CALIBRATION
In order to map the full range of the ESC output to your throttle stick motion you will have to perform an ESC throttle
calibration.
NOTE: Execute ESC throttle calibration with the propeller removed.
1. Power ON your transmitter, DISABLE any throttle hold or throttle kill switches, completely lower the throttle trim
and set the stick to full throttle.
2. Connect the flight pack to your Piraña.
3. Listen for tones coming from the ESC through the motor. After about two seconds, you should hear two tones.
4. Pull the throttle stick back to idle.
5. Listen for the ESC to confirm with two tones from the motor, followed by the arming tones.
The ESC throttle range has now been properly calibrated, and is stored in the ESC’s memory until it is calibrated
again. You can repeat this process as many times as necessary.