17
6.
Install the Aft Duct through the very back of the fuselage. Sleeve the Aft Duct to the forward duct.
(final parts may vary slightly from photo)
7.
Fit and install the fan with (2) 3mm x 12mm SHCS with 3mm washers. (Extra holes are provided to aid
in accommodating other fans.)
8.
Plug the Motor and ESC wires together. The wire basically wraps around from the above (top) the duct
at the front, to below (bottom) the duct at the back.
9.
Connect the radio and flight batteries and use the transmitter to carefully run the motor at high idle. If
the thrust does NOT come out the back of the model, remove the fan as needed and switch any 2 motor
wires.
10.
Use quality vinyl tape to secure the aft duct to the fan, and the aft duct to the forward duct.
Summary of Contents for FlexJet Pro 90 mm
Page 1: ...1 Instruction Manual...