Maintenance, Adjustments,
Troubleshooting & FAQ
31
5. Reinstall the black Bumper, Stop Block, and 10mm Bolt. Repeat the adjustments as
describe in “Adjusting the Cutting Head Bearings,” Section 44.-C. on page 28.
VI.
Troubleshooting Your FSC
If this
Troubleshooting Guide
or the
Frequently Asked Questions
listed below does not answer
your questions, call our Customer Service Department at 1.800.843.3826 (within the United States) or
outside the United States, call ++800.843.3826, visit our website (www.fletcher-terry.com) or send an
email to [email protected].
Symptom
Probable Cause
Correction
Plastic Scoring Chatters
Too Much Pressure
Scoring Too Fast
Loosen the Pressure Knob
Slow the Scoring Stroke
Ragged Cut Edge When
Cutting Thin Material
No Sacrificial Sheet
Use New Sacrificial Sheet
Ragged Edges
Cutting Blade is Dull
Use New Sacrificial Sheet
Not Cutting Squarely
Foreign Material on
Horizontal Support
Horizontal Material Support
Bar is Not Installed Properly
Clean
Adjust Bar
(see page 11)
Can’t Depress the Thumb
Lever
Rocker Arm Locking Pin
is engaged
Disengage the Locking Pin
Glass is flaking
Too Much Pressure
Loosen the Pressure Knob
Cutting Head is
Moving Side-to-Side
Cutting Head Bearings
have loosened
“Adjusting the Cutting
Head Bearings",
(see Section 44.-C. on page 28)
