FLETCHER FSC 65, Instruction Manual

Page: 18 / 41

Installation
11
17. Securing the Large Face Plate to the Left Frame Leg
Parts Needed:
Hardware Tools Needed
M6 x 40mm Button Head Screw
(was attached to Bracket “P’)
3mm Hex Key
8mm Wrench
1. Insert the M6 x 40mm Button Head Screw, M6 Flat Washer, and M6 Hex Nut that came
with the Bracket to secure the Large Face Plate to the Left Leg.
2. Tighten the Screw using a 3mm Hex Key and 8mm Wrench.
18. Installing the Horizontal Material Bar
Parts Needed:
Frame Parts Qty. Hardware
See Pg 2
Tools Needed
Horizontal Material Bar
(#5 – Pg 1)
3
3
1 M8 x 25mm Button Head Screw
M8 Flat Washer
Pivot Shoulder Bolt
L
O
M 5mm Hex Key
Square Spacer
(N – Pg 2)
1
2
1 M8 x 110mm Socket Cap Screw
M8 Flat Washer
M8 Hex Lock Nut
V
O
R
6mm Hex Key
13mm Wrench
♦ Note: Release the Clamp, if you repositioned it in the previous step.
1. Locate the opening between the Clamp Assembly and the Vertical Track Assembly. This is
where the Horizontal Material Bar will be positioned
.
2. Slide the Horizontal Material Bar in the opening from the right side of the machine below
the Clamp mechanism.
3. Pull the Horizontal Material Bar all the way over to the left until it is resting on the Squaring
Ramp.
♦ Note: The notch of the Horizontal Material Bar will be positioned in the notch of
the Vertical Track Assembly.
4. Lift at the center of the Horizontal Material Bar to align the holes between the Horizontal
Material Bar and the Horizontal Brace Channel.
5. Insert the Pivot Shoulder Bolt into the hole directly to the right of the Vertical Track Assembly.
6. Tighten using a 5mm Hex Key.
7. Insert the three (3) M8 x 25 Button Head Screws with three (3) Flat Washers starting from
the far left of the Horizontal
Material Bar.
¾
Tip: Make sure the Horizontal Material Bar is positioned on the Squaring Ramp
and flush to the Horizontal Brace Channel.
8. Position the Square Spacer between the Horizontal Brace
Channel and the Right Leg so the holes line up.
¾
Tip: You can pull back the right leg to make more
room to place the Spacer.
Spacer set between the
Horizontal Material Bar
and the Right Leg