04
IMPORTANT
Before removing or installing the Cup Nº02 (Pic.01) be sure the motor has
completely stopped in order to avoid coupling premature wear out.
3.1 Starting
The Blender is activated by turning the On/Off Switch Nº08 (Pic.01) located in the
Motor Housing Nº05 (Pic.01) to ON position.
The Heavy Duty Industrial Blenders were developed for easy cleaning. Wash the
removable parts with running water and neutral soap and wipe up the others with a damp cloth.
IMPORTANT
The processing time depends on the kind of product. It is not recommended to
blend products without the addition of any liquid; otherwise it will overheat and
damage the Cup seal.
IMPORTANT
NEVER SWITCH THE MACHINE ON WITHOUT LOAD IN IT
BECAUSE IT WILL CAUSE IRREPARABLE DAMAGES.
3.2 Operating Procedures
The Heavy Duty Industrial Blender work at high speed, approximately 3.500 rpm.
To feed it proceed as follows:
1 – Remove the Lid Nº01 (Pic.01).
2 – Put product inside the Cup Nº02 (Pic.01) with the machine switched OFF.
3 – Place the Lid Nº01 (Pic.01) back on top of the Cup and switch the machine ON.
3.3 Cleaning
IMPORTANT
Always unplug machine before cleaning. Before removing the Cup be sure the motor
has completely stopped. When washing inside the Cup be careful with the blade.
3. Operation
05
4.1.1 Dangerous parts
Some parts of the electric devices are connected to high voltage points. These
parts when touched may cause severe electrical shocks or even be fatal.
Never touch commands such as buttons, switches and knobs with wet hands , wet
clothes and/or shoes. By not following these instructions operator could be exposed to severe
electrical shocks or even to a fatal situation.
4.1.2 Warnings
The operator has to be well familiar with the position of ON/OFF Switch to make
sure the Switch is easy to be reached when necessary. Before any kind of maintenance, physically
remove plug from the socket.
Provide space for a comfortable operation thus avoiding accidents.
Water or oil spilled on the floor will turn it slippery and dangerous. Make sure the
floor is clean and dry.
Before giving any manual command (switch, buttons, turn keys or lever) be sure
the command is the correct one. Check this manual for further details if necessary.
Never use a manual command (switch, buttons, lever) unadvisedly.
If any work is to be made by two or more persons, coordination signs will have to
be given for each operation step. Every step of the operation shall be taken only if the sign has been
made and responded.
Follow the below instructions for washing removable parts:
3.3.1 Unplug the machine.
3.3.2 Remove the Lid Nº01 first then the Cup Nº02 (Pic.01).
3.3.3 Wash all removable parts with running water and neutral soap.
3.3.4 To reinstall them, follow the above order inversely.
The following safety instructions are addressed to both the operator of the machine
as well as the person in charge of maintenance. The machine has to be delivered to the operator in
perfect conditions of use by the Distributor to the user. The user shall operate the machine only after
being well acquainted with the safety procedures described in the present manual. READ THIS
MANUAL WITH ATTENTION.
4.1 Basic Operation Practices
IMPORTANT
When washing inside the Cup be careful with the blade as it has sharp edges.
4. General Safety Practices
Summary of Contents for L - 02
Page 2: ......
