AMG1000ALx-VCM Light Duty/Passenger Vehicle Kit Installation Guide
7
Wiring Harness Installation Overview
Figure 6 shows the wiring harness installation overview. The following section provides the
detailed installation instructions.
Figure 6: Wiring Harness Installation Overview
VBATT (Red)
IGN_SEN (Brown)
GND2 (Black)
Molex MiniFit Connector
Plugs into AMG base unit
1
2
4
3
5
6
8
7
5 = OWDAT
6 = CAN_L
7 = CAN_H
8 = VBATT
Pinout:
1 = GND1
2 = IGN_SEN
3 = DIG_IN1
4 = GND2
WIRING HARNESS
AMG base unit (Connector Side)
VEHICLE FUSE PANEL
GND1 (Black)
Attach the ring terminal of the
GND1 (long black) wire to a good
chassis ground point inside the
vehicle. These can usually be found
near the fuse panel and/or stereo.
Alternatively, the shorter GND2 wire
can be used if there is a chassis
ground point close to the AMG.
Connect the Ignition Sensor wire to a spare fuse
position which has a “switched” 12V (only live
with ignition and accessory) via an “add-a-circuit”
device or by direct splice, including a 3A inline
fuse, if there is not enough clearance for the
“add-a-circuit” device.
DIG_IN1 (Violet) [
NOT USED
]
OWDAT (Blue) [
NOT USED
]
CAN_H (Yellow) [
NOT USED
]
CAN_L (Green) [
NOT USED
]
These wires on the harness
are not used. They can be
bundled together and tucked
out of the way.
Add-a-Circuit
(JHFUSE-14)
Add-a-Circuit
(JHFUSE-14)
Connect the VBATT wire to a spare fuse position
which has a constant 12V (battery) via an
“add-a-circuit” device or by direct splice, including
a 3A inline fuse, if there is not enough clearance
for the “add-a-circuit” device.
