AMG1000ALx-VCM Light Duty/Passenger Vehicle Kit Installation Guide
5
To attach the antenna, first remove the nut. Feed the cables through the hole, seat the
antenna on the surface, and then reattach the nut. The nut should be tight (5 ft. lbs. max) in
order to properly seal the gasket. Tighten the nut with a wrench. For unforeseen conditions,
silicone may be added around the base of the antenna. Finally, feed the cables to the AMG
inside the cab.
A good install location will be one that:
•
Is not visible to the driver
•
Will allow the technician to be able to see all four LEDs on the unit.
•
Allows easy access to the GPS, CDMA, and GSM connections on the unit
•
Enables the AMG base unit to be secured via screws, such that the screws are not
visible to the driver.
PROCEED WITH INSTALLATION ONLY AFTER
THE ABOVE TASKS HAVE BEEN COMPLETED
Note:
If the underside of the threaded base bolt is exposed to the environment, a sealant is required.
