Setting the line width
The line width is determined by the width between the guide discs and
the nozzle height. Both must be adjusted correctly to obtain a good line
with the optimum paint usage. A ruler is located in the nozzle post for
measuring the line width and the nozzle height.
1. With the line forming discs resting on the ground, compress the
spring collars and slide the line forming discs in or out to achieve the
desired line width.
IMPORTANT:
Both the line forming discs must be adjusted so that
the nozzle is central between them.
Setting the nozzle height
1. Hinge the nozzle post to the vertical position. Adjust the nozzle
height by squeezing the spring collar and sliding the nozzle post up
or down for the desired line width. A ruler is provided in the nozzle
post.
2. A reference guide is located underneath the bonnet and give approx-
imate nozzle height for a range of line widths. NOTE: this is only in-
tended as a guide. The operator must observe the spray pattern and
adjust the nozzle height to form a good line for the local conditions
(Fig 13)
Nozzle post
Spring Collar
Line forming disc
Ruler
O
pera
tio
n
8
