MLT-400i Installation Guide
Introduction
Introduction
1
This installation manual covers the installation of the
MLT-400i
and
MLT-400iO
.
The
MLT-400i/O
includes a GPS receiver and a two-way satellite communications modem.
Options include a built-in, on-board diagnostic interface (OBDII), an in cab Message Display
Terminal (MDT) and ignition disable relay.
Recommended Equipment
•
Digital Volt/Ohm Meter (DVOM)
•
Soldering iron/solder
•
Wire strippers/cutters
•
Cordless Drill
•
Drill bits (step bit or Unibit, #36,
19/32”, etc.)
•
Flash light
•
Standard and Metric socket set
•
Screwdrivers (standard, Phillips,
Hex, Torx)
Recommended Supplies
sealant
screws
e
) for tamper
Installation Checklist to capture required installation and system
alidation information.
ation. Phase 2 is system
validation.
the
modem IMEI Serial Number(ESN):
•
Electrical tape
•
Velcro
•
Silicon
•
Tie-Wraps
•
Sheet metal
•
18 gauge wire
•
2 amp ATC fus
•
Torque Seal (blue
deterrent
Installation Documentation
Appendix B includes an
v
•
The checklist is designed to be com-
pleted in two phases. Phase 1 is instal-
lation inform
•
You will need to locate the Electronic
Serial Number on the label located on
the back of the unit. This identifies
Vehicle Name(Asset Name) to the
11/18/2009
FMS MLT-400i Installation Guide 4.3
4
