Installing Your Fleck 7000SE Water Softener
The systems require that a 120 volt standard outlet be
available for powering the system. The 7000SE valve has
a 5' cord with a special low voltage transformer that will
plug into a standard 120 volt outlet.
Pre-Installation Adding the Resin to the Water Softener
Tank
1. Position your new softener unit in place, where you want
it to set.
2. Inside your Softener tank is a 1” or 1.25” Pvc tube "
called a pilot tube" Use a pvc slip cap or some duck tape
to temporarily plug this tube (this is to keep the resin from
going down the tube) Use the special funnel we supplied
you, to add the resin to the tank, this will take about 10
minutes to do. After adding the resin, remove the cap,
clean the threads on the tank with water were the valve
screws onto, and screw the valve on, the tube will slip into
the bottom of the valve hole as you are screwing that
valve onto the tank.
Adding resin to the tank.
Page 1 of 7
Copyright © 2006 Quality Water Treatment, All right reserved. www.qualitywatertreatment.com
