Flavor Burst CTP 80BEV-INT-2S, Operation Manual Supplement

Page: 43 / 46

42
25. Locate the ethernet cable on the inside of
the Taylor back panel. It is a thick black
cable with an ethernet jack. Connect it to
the ethernet port on electronics board,
located at the middle top edge of the board.
26. Install the electronics plate to the inside of
the Taylor modified back panel using the
screws provided.
27. Channel the 9-Tube Assembly tubes
through the slot on the modified Taylor back
panel. Use the slot closest to the side of the
freezer the 9-Tube Assembly is installed.
28. Pull open the plastic grommet and place it
around the 9-Tube Assembly tubes. Snap
the grommet into the hole on the modified
Taylor panel.
29. Install the plastic plug into the other hole on
the modified Taylor panel.
30. Install the modified back panel to the Taylor
cabinet and reinstall the side panel.
31. Slide the modified front panel onto the
screw posts of the Taylor cart, lift the panel
up under the cart cap.
32. Secure the front panel with a thumb screw
at the bottom of the panel.
26439
26412
26412
26417
26414
26416
26408
26429