3.5.5
3.5.6
In the unlikely event of the EFC switch malfunctioning the fire
can be controlled from the valve, which is located behind the
ash-pan cover on the fire, see section 3.4 for full manual operating
instructions. If your fire does not operate manually please consult
the troubleshooting chart on the rear page of this manual.
3.6
LIGHTING THE APPLIANCE - MANUAL CONTROL MODELS
3.6.1
Turn on the gas isolation tap.
3.6.2
Depress the control knob and turn anti-clockwise to the position
marked ignition / low rate. Hold in the control knob for a few seconds to
purge the pipe work.
3.6.3
Continue to hold-in the control knob and press the igniter button. If the
burner does not light, continue to press the igniter button until ignition
occurs. Continue to hold the control knob for a minimum of 20 seconds
to allow the thermocouple to heat up, if the burner goes out when the
control knob is released, repeat the lighting sequence.
3.6.4
Turn the control knob in the anti-clockwise direction to the high position
and the gas rate will increase to high rate (6.5 kW)
3.6.5
Turn the control knob clockwise to the low position and the gas input
will be reduced to the minimum setting (2.2 kW)
3.6.6
Slightly depress the control knob and turn to the off position, the burner
will now be extinguished.
WARNING : If the fire goes out for any reason or is turned off and it
is necessary to re-light the fire it is important to allow the
fire to cool for 3 minutes before attempting to re-light it.
3.7
FITTING THE TRIM
3.7.1
The trim is held in position on the fixing flange by magnets.
3.8
FITTING THE FENDER
3.8.1
The fender is placed up to the front of the ceramic front rail on
all models. Position the ashpan under the fender and centralise.
25
If you are not intending to use the fire for a long period (i.e.
over the summer months) the battery life can be extended by
sliding the power isolator switch to the left (to the “0” position
away from the “1” position) on the valve itself, which is located
behind the ashpan cover on the fire.
