5.4
OPERATING THE FIRE - REMOTE CONTROL MODELS
5.4.1
The controls comprise a remote handset, to turn the fire on and off and
adjust the gas rate. Ensure valve power isolation switch is in the on
position - see figure 3. Hold the handset with one hand ensuring your
hand is wrapped around the back and that your hand is in contact with
both sides of the handset. The green light of the “unlock” symbol
should light. See figure 1 below.
5.4.2
Press and hold the power button continuously until the red light
illuminates next to the operation symbol (this typically takes two
seconds). As the red light illuminates release immediately the power
button. The red light will the flash as the burner is being lit. While the
burner is lighting the red light will flash. When the burner has lit the red
light will stop completely. The burner will now be lit at maximum heat
input level. NOTE : If the power button is pressed for too long or two
short a time or the grip on the handset is not firm or is released too
soon, the lighting sequence will be interrupted and not complete. The
reason for the remote control having this strict start sequence is for
safety reasons so that the starting operation of the fire will be most
unlikely to be done other than intentionally by an adult.
Fig. 1
29
Power button
Unlock symbol
(illuminates green)
Operation symbol
(illuminates red)
+ button (increases
heat input level)
- button (decreases
heat input level)
