d)
Obtain the allen key which is located at the bottom left hand side if
the firebox.
e)
Loosen each allen bolt a small amount at a time to prevent damage
to the glass panel. (See Fig. 1) When all the allen bolts have been
removed, lift away the glass frame and clean
as per the instructions on page 6.
f)
Refit the glass panel to the firebox, again tightening each bolt a
small amount at a time to prevent stressing the glass panel. Fully
tighten all the bolts to ensure good compression on the glass panel
seal.
g)
Refit the brass trim, ashpan & fret to the firebox.
FOLLOWING USE OF THE ALLEN KEY, ALWAYS REMOVE IT FROM THE
FIRE AND REPLACE IT INTO ITS LOCATION IN THE CLIP AT THE BOTTOM
LEFT HAND SIDE OF THE FIREBOX.
REMOVAL / RE-FITTING OF THE FUELBED
FITTING THE FUELBED
Place the fuelbed centrally onto the fuelbed support. Ensure that the fuelbed is
located centrally into the firebox, and that the front outside face of the left and
right-hand fuelbed legs are touching the stainless steel fibre support trims.
See fig. 2 below
Fig. 2
7
NOTE : The position of the fuel-bed components are critical to the
performance of the product. Therefore please ensure that the fuel-bed
components are positioned as described in the following section prior to
requesting a service call due to soot build up, poor flame pattern etc.
