Always keep furniture and combustible materials well clear of the fire and never
dry clothing or items either on or near to the fire. Never use aerosols or
flammable cleaning products near to the fire when it is in use.
The fuel bed remains hot for a considerable period after use and sufficient
time should be allowed for the fire to cool before cleaning etc.
The fire must only be operated with the fender and canopy supplied and in
position.
OPERATING THE FIRE
This appliance is designed so the pilot burner runs constantly, and the touch
control is used to operate the main burner only. The touch control can not be used
to light the pilot burner. The pilot burner control and main gas valve are located
behind the fender.
The control valve features two control knobs, the left hand one to light the pilot,
and the right hand one to adjust the heat input to the appliance from high (5.20kW)
to low (2.05kW). Fig. 1 below shows the control valve.
Fig. 1
Lighting the Pilot
To light the pilot, press the knob in and turn it anticlockwise. (It may be necessary
to hold the control knob in for a few seconds to purge air from the pipe). Once
gas is available at the pilot, by turning the control knob further anticlockwise the
piezo igniter will cause a spark at the pilot to light the pilot burner. Once the pilot
burner is lit, hold the control knob depressed for approximately 10 seconds to hold
the flame supervision device in. Let the control knob go and the pilot should
remain lit, if the pilot goes out repeat the lighting sequence. Turn the control knob
to the large flame position, this will allow gas to the main burner section of the
control valve.
4
Pilot
Control
Knob
Main Burner
Control
Knob
