d)
Remove the valve retaining screws as shown below in Fig. 17
Fig. 17
e)
Remove the thermocouple, which is a push fit into the rear of the control
valve.
4.4
REMOVING THE ODS- PILOT ASSEMBLY
Note : Because this appliance is fitted with an atmosphere sensing ODS-pilot
it is not possible to replace the thermocouple separately, because the
thermocouple position is factory set to a tight tolerance. Any replacement of
parts on the pilot requires a complete new pilot assembly.
a)
Remove the pilot retaining screws as described in section 4.2 d) &
fig. 14
b)
Disconnect the pipe pipe and push fit ignition lead
c)
Replacement new ODS in reverse order, and carry out a gas tightness
test.
PARTS SHORTLIST
Replacement of any parts must be carried out by a competent person such as a
CORGI registered gas installer. The part numbers of the replaceable parts are as
follows, these are available from specialist spares stockists whose details can be
found on our web site,www.cfm-europe.com, in the ‘stockist’ section.
Coal set
FC-P085332 ODS Pilot (NG)
B-48360
Fuelbed
FC-P085339 ODS Pilot (LPG)
B-66920
Gas valve (NG)
B-63250
Gas Valve (LPG)
B-66930
Rear Fibre board
B-65320
Glass Assy (Front)
SFA-085165
20
2 off valve
retaining screws
Summary of Contents for Emberglow Classic FEMC00MN
Page 30: ......