FLATLIFT Slimeline 50, Operating Manual, Page: 16 / 18

P.016
Operating Manual
O u t p e r f o r m . O u t l a s t .
Anschluss an eine Raumsteuerung:
To assable your Flatlift Slimline to the room control
system, disconnect the contacts 2-5 (Abb.4).
Connect these cables with the relay outputs of
your room control system (Img.5).
The relays of the room control system should be
open as the case of may be close for 120 sec.
Image 3
2
3
4
1
Image 5
PRODUCT CONTROL
PRODUCT CONTROL
Image 4
Receiver contacts (Img.4):
Contact 1:
Contact 2:
Contact 3:
Contact 4:
Contact 5:
Contact 6:
Contact 7:
Contact 8:
Contact 9:
Contact 10:
unused
open outlet
open inlet
close outlet
close inlet
unused
power 12V
power supply 0V
unused
add on antenna
C.06:
Resetting the receiver:
It may sometimes occur that the transmitting codes stored in the receiver are lost.
In this case, the receiver must be cleared and re-programmed.
1) To access the programming key, remove the cover (image 1, no. 1) on the receiver.
2) Press down both of the programming keys (image 3, no. 2 + 4) until the LED (image 3, no. 3) rapidly
flashes. This is the signal that the memory has been successfully cleared.
3) Now re-enter your remote control (refer to P.
15
).