FlashPoint FPLFSMZ, Manual, Page: 7 / 20

06
Disabling Auto Power Off function is recommended
when the flash is used off camera.
See the Custom Function Menu section.
Slave Auto Power Off Timer is set to 10 minutes by
default. Other options are available.
See the Custom Function Menu section.
1.Power Management
Use ON/OFF Power Switch to power the flash unit on or off. Turn the
flash off if it will not be used for an extended period of time. This flash
unit has Sleep Function and will enter into sleep status when there
is no operation.
Figures displayed when reducing flash output level
→
←
Figures displayed when increasing flash output level
1/1 OF 1/2 1/4
1/1-0.3 1/1-0.7
1/2+0.7 1/2+0.3
1/2-0.3 1/2-0.7
1/4+0.7 1/4+0.3
2.Flash Output
Flash output can be varied from 1/128th power to 1/1 full power
in 1/3 stop increments. To obtain a correct flash exposure, use
a hand-held flash meter to determine the required flash output.
Adjust the power output by rotating Select Dial. The following
table makes it easier to see how the power changes in terms of
f/stop when you increase or decrease the flash output:
3. ZOOM: Setting the Flash Coverage
The flash coverage can be set to match the lens focal length or for
spotlighting effect from 24 mm to 200 mm. Press button
and rotate Select Dial to change the flash coverage.
When “OF” is shown on the LCD display, it means flash
firing is turned off.
When setting the flash coverage, make sure it covers the lens
focal length so that the picture will not have dark edges.