Flashforge Guider 2, Quick Start Manual, Page: 9 / 28

7. If the distance is appropriate, tap [ok] to next
step. If the diastance still not appropriate, please
follow the prompts on the touch screen to
adjust till you see [ok].
Tap the [OK] button to move to
the next leveling point.
Congartulations
Screw the three nuts under the platform
counterclockwise until they are tight,
then tap the [OK] button.
3. Please wait while the extruder and platform finish initial movements. Screw three nuts under the
platform anticlockwise, then tap [OK] button.
Attention: three nuts may be tightened up before going out, please skip this step if you find
three nuts have been tightened up, and continue to following steps
4. After tapping [OK] button, the extruder will
move towards the first point and the plate will
move up and down to verify the distance
between nozzle and plate.
6. Then tap the [Verify] button to check whether
the distance is appropriate.
5. If the distance between the nozzle and plate
is too large, rotate the three nuts underneath
the platform clockwise for the same rounds
until you hear a steady beep.
08