1. Loosen the screws indicated in the picture and take out the resin box. Remove the
remaining resin and clean the box.
2. Turn the box up side down and loosen
the screws on the base. Take out the FEP
membrane module to be replaced.
4. Place the FEP membrane at the bottom
of the resin box.
5. Tighten the screws on the four corners
first.
3. Clean the bottom of the resin box and
the screws, and prepare a new module.
Note: Do not touch and leave fingerprints
on the membrane which will affect printing.
15
Replace the FEP film in the resin box