www.flash-butrym.pl
8
CAUTION! In the case of cable damage do not attempt to repair. Replacement or repair can be made only
on the manufacturer or by a person with appropriate permissions.
6
MAINTENANCE AND CLEANING
The following points have to be considered during the inspection:
1.
All screws for installing the devices or parts of the device have to be tightly connected and must
not be corroded.
2.
There must not be any deformations on the housing, color lenses, fixations and installation
spots(ceiling, suspension, trussing).
3.
Mechanically moved parts must not show any traces of wearing and must not rotate with
unbalances.
4.
The electric power supply cables must not show any damage , material fatigue or sediments.
5.
Further instructions depending on the installation spot and usage have to be adhered by a skilled
installer and any safety problems have to be removed.
CAUTION! Disconnect from mains before starting maintenance operation.
In order to make the lights in good condition and extend the life time, we suggest a regular cleaning to the
lights. 1) Clean the inside and outside lens each week to avoid the weakness of the lights due to
accumulation" of dust. 2) Clean the fan each week. 3) A detailed electric check by approved electrical
engineer each three month, make sure that the circuit contacts are in good condition, prevent the poor
contact of circuit from overheating.
We recommend a frequent cleaning of the device. Please use a moist, lint-free cloth. Never use alcohol or
solvents. There are no serviceable parts inside the device. please refer to the instructions under "Installation
instructions". Should you need any spare parts. Please order genuine parts from your local dealer.
7
OPERATION MANUAL
7.1
Operation instructions
The moving head is for wash effect for on-site decoration purpose.
Don't turn on the fixture if it's been through severe temperature difference like after transportation
because it might damage the light due to the environment changes. So make sure to operate the
fixture until it is in normal temperature.
This light should be keep away from strong shaking during any transportation or movement.
Don't pull up the light by only the heed, or it might cause damages to the mechanical parts.
Don't expose the fixture in overheat, moisture or environment with too much dust when installing
it. And don't lay any power cables on the floor. 0 r it might cause electronic shock to the people.
Make sure the installation place is in good safety condition before installing the fixture.
Make sure to put the safety chain and check whether the screws are screwed properly when
installing the fixture.
Make sure the lens are in good condition. It's recommended to red lace the units if there are any
damages or severe scratch.
Make sure the fixture is operated by qualified personnel who knows the fixture before using.
Keep the original packages if any second shipment is needed.